DIAVEL FRONT  exhauts shield . HAs thermal tape on inside,  Insist on Autoclave. DON'T  BUY CHEAP WET LAYUP OR FAKE

Our Manufacturing process

Racecon Carbon fiber is pre-impregnated (i.e. pre-preg) with epoxy resin. It is then laid into the mold and  covered with releasing films and agents. The entire piece is then bagged and vacuumed clean of air. From there the piece is inserted into an autoclave, which is, basically, a large oven. The parts are heated to cure the carbon fiber and then the part is finished. Dry carbon parts can be produced with a much lower weight than wet lay-up parts since there is much less resin used (hence the “dry” name) and with a higher strength.

Don’t use cheap wet layup product  . Our prices are competative by our lean overheads.

Call 0466507457 for more information or Racecon.com.au