New ANT SWR Antenna Analyzer Meter shortwave For SARK100 Ham Radio Hobbists

100% Brand New And High Quality

This is a SWR Analyzer for ham hobbists.

Frequency Generation & Control: 1 - 60 Mhz

Source impedance: 50 Ohms

Stability: +/- 100 ppm

Spectral Purity: Harmonics down >- TBD dB beyond 60 MHz

Step Size: User configurable increments of 100 Hz, 1 kHz, 10 kHz, and 100 kHz

Usable Measurement Range:SWR: 1.0 to 9.99

Impedance: approx. 5 to 2000 ohms

RF Output: Adjustable: 2.0 Volts pp (typ)

Power supply: Powerd by External: 12 to 15 Volts DC, 500mA

Controls: Pushbuttons (5): "Mode", "Band", "Config", "Scan", "Up", "Down"

Switch: "Power On"

Connectors: RF Out: BNC

USB: Mini-B receptacle

External power: 2.1mm Power Jack (center pin positive)

Applications:

Measure antenna electrical parameters: SWR, impedance (resistance +

reactance), capacitance, inductance

Measure feedpoint impedance

Measure ground loss

Adjust antenna tuners and determine loss

Measure inductors and capacitors

Measure coax transmission line (SWR, length, velocity factor, approximate Q

and loss, resonant frequency, and impedance)

Measure and determine optimum settings for tuning stubs: SWR, approximate

Q, resonant frequency, bandwidth, impedance

Determine characteristic impedance of transmission line

Determine length of ? and ? wave phasing lines

Coaxial Cable Loss

Determine antenna tuner loss

Measure balun loss

Measure inductor Q

Estimate quartz crystal parameters

Measure magnetic loop resonance and SWR

Operation button definitions:

Mode: selects operation mode: impedance(default), complex impedance, capacitance, and inducatance

BAND: select band from any of the available bands: 160M to 6M

CONFIG: Provides menu for configurations and extended functions: PC Link, step size setting, suspend timeout setting, calibration, and software upgrade

SCAN: pressing this control initiates a scan of frequencies of the selected BAND. Scan exits to impedance mode showing the 2:1 bandwidth and the resonant point o the antenna

CAN(up): increase frequency and used to cancel operation for CONFIG menu

VAL(down): decrease frequency and used to validate operation for CONFIG menu

More information pls see the manual - http://www.filedropper.com/sark100-usermanual_1

Package includes:

1 x ANT SWR Antenna Analyzer Meter For SARK100 Ham Radio Hobbists