This charge controller designed and assembled in England  will control 12V/600W wind generator (or less) and 12V/600W solar panels (or less) in hybrid setup, effectively it will control up to 1200W.

When used with solar panels: regulator will disconnect the solar panel(s) when batteries voltage will reach preset value (cur. set at: 14.0 volts),
it will connect the solar panels to the batteries again when batteries voltage will drop to 13.0

When used with wind generator only it will connect dump load to the batteries when batteries voltage will reach preset value (14.0V) then it will disconnect the dump load
when batteries voltage will drop to 13.0V.

When used in hybrid setup with wind generator and solar panels it will disconnect the solar panels when batteries voltage will reach preset value (14.40) and connect the dump load. When batteries voltage will drop to 13.0V it will connect the solar panels to the batteries again and disconnect the dump load.

Batteries voltage can be adjusted by the user. (Positions of signal lights and voltage adjusting screw may vary.)

In the package you'll get: 12V/600W charge controller, 12V/600W dump load, all the necessary cables to connect the charge controller and the dump load to the battery plus 100A 3 phase bridge rectifier.

This set can be connected to AC wind generator, instruction "how to connect" also included in the package.

12 months guarantee!