Impossible to find.... Alesis dm10 Pro drum trigger. Has your bass pad stopped working? This part can be used to replace the broken trigger sensor on your pads or bass drum. Not for kits with rubber pads. This is for DM kits with heads. The correct length of wire has been neatly pre soldered to the trigger to allow you to solder this directly onto the female jack socket on your pad. (Wire red lead to the resistor and black to the connector) note a heavier gauge wire has been used than the original wires which are too thin and very difficult to solder and easily break. Pads photographed are not included in this sale. Only the small trigger that is inside. Very hard to get the correct new replacement item with the correct capacitance for the alesis dm10 kits. Save yourself £100 from buying a new pad and fix it yourself! Limited number available. Check out my feedback from the last buyer of this item.