· Displays 6 parameters at a time
· High visibility large display
· Many parameters to choose from (see list)
· Compatible with Megasquirt
· Easy to wire up and tune
· Each parameter has a safety warning level
· Firmware updates over serial port
LDperformance RACE DASH can connect to an ECU and pull all required data from there. Also it supports a number of sensors which can be directly connected to the DASH.
There is firmware for DTAfast S series using CAN bus or serial interface.
Also supported is Megasquirt ECU. The connection is done through the supplied serial port cable. The list of parameters the DASH can use from Megasquirt is:
RPM
BOOST
AFR
Coolant Temp
Air Temp
Injector Duty Cycle
Spark angle
Battery Voltage
etc..
LDperformance DASH can display additional parameters if the suitable sensors are connected. It can also be used in standalone mode without connecting to a Megasquirt ECU. The list of possible parameters is:
AFR – 0-5V input compatible with most wideband controllers and LDperformance wideband
RPM – Detects RPM from negative wire of injector or ignition coil
Coolant / Air / OIL temp – 1/8npt temperature sensor available
OIL / Fuel pressure – 1/8npt pressure sensor available up to 10 bar (150psi)
EGT – 2 channels of Exhaust gas temperature measurement – EGT probe available separately
Battery voltage
Device temperature
External signal Duty cycle and time low
EGT sensors and pressure / temperature sensors available at
3D printed enclosure does not look smooth.
Includes:
LDperformance DASH
Connector and wiring
Additional sensors not included.