• Nokia 5110 LCD Module, Arduino Compatible
• You will Need: ( NOT Included in this Listing ! ) Set of Two 1K Resistors      ( For Safe Operation ) Set of Four 10K Resistors   ( For Safe Operation )
• Pin Connections
  1．RST--------- reset.
  2．CE------------chip selection.
  3．DC-----------data/commands choice.
  4．DIN-----------serial data line.
  5．CLK------------serial Clock Speed.
  6．6．VCC----------Power, 3.3V (Positive).
  7．LIGHT--------- backlight control terminal.
  8．GND-----------power negative.
• Power supply voltage: 2.7V - 3.3V
• Backlight Power Supply Voltage: 3.3V MAX
• 43.6mm x 43.1mm(width X height)
• 84 x 84 dot matrix LCD,can show 4 lines of characters, 12 Characters Per Line
• Uses Serial Peripheral Interface (SPI) to communicate with the microcontroller, only 8 signal lines including power and GND. Support different types of MCU (MicroController Unit) , such as Arduino, PICAXE, ARM, Raspberry PI etc. Transfer rate up to 4Mbps,can full speed write display data without waiting time.
• LCD controller/driver chip has been bound to LCD chip so the overall footprint of the LCD Module is Kept as small as possible.
• Has TWO Rows where header pins can be soldered for greater flexibility of use!
• Low power supply, the working current in normal situation is lower than 200μA,and has power-down mode.

Package Include：