THIS 20PIECE KIT IS COMPILED TO FIX THE POWER SUPPLIES LISTED BELOW WITH SYMPTOMS RANGING FROM QX801/QX802 SHORT CAUSING CLICKING OR STUCK IN STAND BY AND NA V/A VOLTAGE OR VS VOLTAGE PLEASE MAKE SURE YOU GET THE RIGHT KIT IF QX801/802 IS SHORT THIS IS THE KIT (KIT15 A/B ), BUYING FRESH POWER SUPPLY FROM EBAY IS WASTE OF MONEY ,WHEN YOU CAN IMPROVE YOUR ORIGNAL POWER SUPPLY WITH THE FRACTION OF THE COST.
FOR ALL MY FELLOW TECHS I HAVE COMPLIED THIS KIT WHICH I BEEN USING PAST 2 YEARS WITH SUCESS MAKE SURE YOU GET THE RIGHT KITS IF YOU FIND QS801/802 SHORT ORDER KIT16 A/B FROM MY OTHER LISTING YOU DONT NEED THIS KIT THEN.
KIT WILL BE SUPPLIED WITH PARTS TO IMPROVE THE POWER SUPPLY ,KIT COMES WITH MAIN PCB PARTS AND MODULE 1 PARTS/MODULE 2 PARTS
SIMPLE TO FIT PLEASE BE AWARE THIS KIT INVOLVES, SOLDERING AND DESOLDERING SMD TRANSISTORS AND DIODE/ RESISTORS. YOU MUST HAVE GOOD SOLDERING SKILLS
GOOD LUCK AND THANKYOU FOR LOOKING :)
SAMSUNG PLASMA TV POWER SUPPLY 30 PIECE REPAIR KIT 15/A/B
MODELS COVERED
PS42Q96HD, PS42Q97HD, PS42C91HD
PS50Q96HD,PS42Q97HD,PS42C91HD
MANY OTHER MODELS ARE APPLICABLE
PSPF531801A PSPF411701A
BN44-00161A BN44-00189A
BN44-00161A
PLEASE MAKE SURE THE BOARD NUMBER MATCHS FOR THIS KIT
MAKE SURE YOU HAVE RIGHT TOOLS FOR SMD SOLDERING, OPTO COUPLERS
SOLDERING TEMP MUST BE BELOW 214 OR DEVICE WILL BE DAMAGED
THIS KIT CONTAINS 99.9% OF PARTS REQUIRED TO FIX MOST OF FAULTS THAT HAVE BEEN CAUSED BY DRY JOINTS ON FETS OR PREMATURE FAILURE OF THE OUTPUT FETS ,PLEASE AS YOU FIT THE KIT CHECK NEARBY COMPONENTS FOR ANY DAMAGE,JUMPER WIRES MUST BE SOLDERED TO THE POINTS THAT HAVE BEEN NOTED IN THE INSTRUCTIONS,SCRAPE AWAY PRINT IF NECESSARY TO MAKE GOOD CONNECTIONS,
FAULT SYMPTOMS
DEAD,RELAY CLICKING,NO VS VOLTAGE,NO VA VOLTAGE,
IF QX801/QX802 SHORT ( 9N50C/11N50C ) THIS IS THE RIGHT KIT (KIT15)
PLEASE REPLACE ALL THE PARTS EVEN IF THEY READ OK !!!!!!!!!!!!
THERE ARE 4 EXTRA SMD RESISTORS PLEASE USE THE 1S FOR YOUR BOARD AND DISCARD OTHER 4 .
THIS KIT WILL TAKE APPROX 25 MIN IF DONE PROPERLY.
PLEASE TAKE YOUR TIME IN DESOLDERING MODULE 1 AND MODULE 2.
RESOLDER ALL EARTH POINTS WITH HIGH TEMP SOLDERING IRON /AND ALL MOSFETS ON THE BOARD.
AFTER KIT HAS BEEN INSTALLED REFER TO STICKER ON THE BACK SIDE OF YOUR PLASMA DISPLAY FOR CORRECT VOLTAGES.
PLEASE SET THE VOLTAGES ACCORDINGLY, I BEAR NO RESPONSBILITY OF MISFITTING PARTS, NOT ADJUSTING VOLTAGES CORRECTLY.
ON SOME MODELS PLEASE CHECK Y SUS FOR SHORTS AND BUFFER BOARDS REFER TO MY OTHER KITS.
PLEASE REFER TO INSTRUCIONS THAT APPLYS TO YOUR POWER SUPPLY NUMBERS ,ON NEXT FEW PAGES
GOOD LUCK