The package including 4 pcs of iFLY® ESC 20A + 4 sets accessory ( 2.0mm banana plugx3 +heat shrink pipex3 ) + 4 pcs iFLY® IF2204 2300KV motors

  • All ifly motors use high temperature rated N48SH Neodymium sintered-magnets for industry-leading performance.
  • Its stator construction uses high grade, 0.2mm silicon steel laminations imported from Japan, which is ultra-high temperature 241 C degree.pure-copper core-winding for optimum efficiency and power transfer. We use High grate Japan NMB brand ball bearingso support the shaft and provide a long life.
  • It's a high efficiency brushless motor with very good price, fit for all DIY quadcopter, drone hobbyist. we ship good fast from USA warehouse and provide customer service.
 
Remark: iFLY 2204 motor designs for 2S/3S Battery, iFLY 2205 motor designs for 4S battery, you can find it in our shop.

The iFLY F390 20A BLHeli OPTO ESC uses the powerful F390 processor, dedicated driver chips on a quality PCB. This gives superior braking and freewheeling performance. The motor braking is exceptionally fast thanks to the Silabs processor along with high quality gate drivers. The ESC is OPTO with no onboard voltage regulator, so you may need a 5v regulator to power your flight controller.
 
The iFLY Little BLHeli is signal wire programmable with an Arduino Nano v3 board, or other Silab programmers that are compatible with the BLHeli bootloader.
 

pecifications:
 
Input: 2-4s Lipo
Constant: 20 Amps
Burst: 35 Amps
Weight: 10g w/wires
Dimensions: 23x12.5x3mm
Main IC:SILABS F396,MCU run 48MHz
Motor wire: 70mm
Signal wire: 100mm
PCB - 4 Layer Blind Pole PCB - 3oz Pour
Mosfet: N-Channel, switch very fast
BEC: None
BLHeli Bootloader & Firmware