This is a new cable direct from the factory

This special cable converts modern voltage GATE signals (V-Trig)
to vintage switch trigger signals (S-Trig).

Typically used to connect a modern keyboard controller or sequencer module to a vintage
MiniMoog, Moog Modular or any other Moog gear that requires a Switch-Trigger signal.

This is not just a passive cable, but an active circuit inside of the connector
shell to do the conversion correctly and retain polarity of the signal.

Built and tested at Synthesizers.com.

This cable is guaranteed to work with all modern modular gate signals and all vintage Moog gear.

Male 1/4" plug on one end and a 2-pin Cinch/Jones plug on the other end.

Length: 48"

Shipping

When ordering more than one item, shipments will be combined
and if cost is significantly less a discount will be issued.

Building giant Synthesizers for serious music creators!