You are bidding on (1) of our Dynaco (registered trademark) MKII (fits small cutout units only) or MKIII amplifier stuffed refit boards, made in the USA. Includes (1) PC-1A (replaces PC-1) board. This was engineered to be a restoration board and as such, follows the original 6AN8 circuit faithfully, including wire hole layout and numbering. THIS IS NOT A MODIFICATION. Board is made of 0.062" FR4 material, is double sided offering plated thru-holes and solder rings/pads on the top side. Board also went through a solder reflow process. This board is silkscreened with component values. Components: ceramic tube sockets, metal oxide and metal film resistors, silver mica capacitors, and Illinois Capacitor metal film tubular capacitors. Please see our other auctions for a pair of boards.  Purchaser must have a copy of the Dynaco MKII or MKIII manual for installation procedure (we DO NOT include the manual with the boards). In general, simply unsolder and remove your old board, install the new board and solder the wires back into the appropriate holes. Please note, we are responsible for the stuffed board only, and once soldered into an amplifier, all warranties and guarantees are voided except where the quality of the board or components is found to be faulty. Thanks for looking and be sure to check out our other auctions as well.

SPECIAL OFFER - FREE brand new VE Tube Pin Straightener (Made In USA) for all orders over $250!!!  Works with 7 pin miniature, 9 pin miniature, Magnoval, Novar, and Compactron tubes.  Also available for individual sale, please visit our store and search for Tube Pin Straightener.