Introduction:
This aluminium alloy moblie robot platform can carry multiple controllers, drivers, sensors and wireless RF module. Users can install IR obstacle avoidance sensor, IR distance measuring sensor, light sensor and ultrasonic sensors onto the front of the plate. The main body of the platform is mad of hard aluminium alloy material, which features light weight, high strength and non-deformation.
Specification:
Reduction ratio of drive motor gear case: 1:48;
No-load rotating speed of drive motor: 200rpm;
Wheel diameter: 65mm;
Wheel width: 26mm;
Platform length: 215mm
Platform width: 205mm
Platfrom height: 65mm
Distance from the chassis to the ground: 13mm;
Working voltage of the motor: approx. 3~6V;
No-load current of the motor: 100mA(160mA at max.)
Speed ratio: 1:48; RPM: 6:200 (low RPM for low voltage, and vice versa);
No-load current: 100mA (max. 160mA)
Package includes:
1 x power toggle switch
1 x metal battery charging port
4 x Double output shaft DC gear motor(can be installed with encoder)
4 x High quality plastic rubber wheel
1 x Double-side six cell AA battery holder
8 x DC gear motor connection cable
1 x Heat shrink tube(around 10cm and can be cut freely)
5 x White ribbon
2 x Connection cable for charging and switch port
One set of 4WD mobile platform (6pcs units in total)