DON'T BE FOOLED BY THE IMPORTED COPYCAT IMITATIONS, THESE ARE THE ORIGINAL MADE IN THE USA VE REFIT BOARDS, WE HAVE BEEN SELLING THESE FOR OVER 15 YEARS:  You are bidding on (1) complete Dynaco (registered trademark) ST70 6GH8A stuffed refit board. Includes (1) PC-3B (replaces PC-3) board. This was engineered to be a restoration board and as such, follows the original circuit where possible, but has been altered to allow the use of the lower cost and plentiful 6GH8A tube.  Wire hole layout and numbering is exactly the same as the original. This a drop in replacement with the exception you MUST use 6GH8A tubes with this board, you CANNOT use the original 7199 tubes once this board is installed.  Please see our other auctions for a selection of NOS 6GH8A tubes, note there is no additional shipping charge if the tubes are purchased and shipped at the same time as the board.  Board is made of 0.062" FR4 material, is doublesided offering plated thru-holes and solder rings/pads on the top side. Board also went through a solder reflow process. This board is silkscreened. Components: ceramic tube sockets, metal oxide and metal film resistors, silver mica capacitors, and Illinois Capacitor and Mallory metal film tubular capacitors.  Note, the Mallory caps might be yellow or white, dependent on which Mallory factory they were mfr'd in.  Purchaser must have a copy of the Dynaco ST70 manual for installation procedure (we DO NOT include the manual with the board). In general, simply unsolder and remove your old board, install the new board and solder the wires back into the appropriate holes. Please note, we are responsible for the stuffed board only, and once soldered into an amplifier, all warranties and gurantees are voided except where the quality of the board or components is found to be faulty. Thanks for looking and be sure to check out our other store listings and auctions as well.  AGAIN THIS IS A 6GH8A DRIVER BOARD AND YOU MUST USE 6GH8A TUBES WITH THIS BOARD, YOU CANNOT USE THE ORIGINAL 7199 TUBES WITH THIS BOARD.  THANKS.

SPECIAL OFFER - FREE brand new VE Tube Pin Straightener (Made In USA) for all orders over $250!!!  Works with 7 pin miniature, 9 pin miniature, Magnoval, Novar, and Compactron tubes.  Also available for individual sale, please visit our store and search for Tube Pin Straightener.