LISTING IS FOR A SET OF REPLACEMENT HARDWARE NEEDED TO REPAIR / REPLACE WORN OUT PARTS FROM PNEUMATIC GAS LIFTS COMMONLY USED ON OFFICE CHAIRS. 

KIT DOES NOT INCLUDE THE GAS LIFT CARTRIDGE ITSELF.  AUCTION IS ONLY FOR THE HARDWARE ON LEFT SIDE OF PICTURE

THIS KIT INCLUDES ALL OF THE PIECES YOU NEED.  THE ONLY OTHER ITEM NOT INCLUDED IN THIS AUCTION WOULD BE THE GREASE FOR THE BEARING. 

WARNING: FAILURE TO USE A LOT OF GREASE WILL DAMAGE THE BEARING AND WASHERS.

IMPORTANT: THE ORDER IN WHICH I AM LISTING THESE PARTS IS THE EXACT ORDER THEY WILL BE PLACED ON YOUR CARTRIDGE (CYLINDER) AS PICTURED.  FAILURE TO PLACE ITEMS IN THE EXACT ORDER MAY RESULT IN DAMAGE AND OR FAILURE OF THE GAS LIFT.

KIT INCLUDES THE FOLLOWING ITEMS. I CAN'T SELL YOU SOME OF THE PARTS ONLY.  YOU HAVE BUY ENTIRE KIT.

• A- 1 RUBBER SPACER
• B- 1 STEEL FLAT WASHER WITH SMALLER CENTER HOLE I.D.  5/16" (VERY IMPORTANT)
• C- 1 BEARING (PUT A LOT OF GREASE ON THE BEARING.  BEARING GREASE NOT DW40)
• D- 1 STEEL FLAT WASHER WITH LARGE CENTER HOLE I.D. 3/8" (VERY IMPORTANT)
• E- 1 RETAINING WASHER
• AT THIS POINT YOU WILL NEED TO PLACE THE GAS LIFT ASSEMBLY BACK INTO THE HOUSING UNTIL END COMES OUT OF BASE OF HOUSING.
• F- 1 FLAT THIN WASHER
• G- 1 RETAINING CLIP