FVT Little Bee 20A ESC
A 20A ESC specifically for multi-rotors, designed to operate on 3s or 4s and supporting bursts of 30A when you need awesome performance, light-weight and conveniently small dimensions. The LittleBee speed controllers arrive factory-flashed with BLHeli firmware supporting OneShot125 and damped mode to give ultra fast throttle response.
LittleBee is using Silabs processor and fast dedicated driver chips, providing excellent freewheeling and exceptional braking capabilities.
High Reliability
We're only using the best components available, period. And, as we build these in our own factory, our experienced staff ensures you're getting the best of the best!
BLHELI firmware
To unleash it's full potential, LittleBee has been designed to run BLHELI firmware. Factory flashed with BLHELI 14, it's ready for action!
Small Size
We know that with mini quads, every gram counts. LittleBee is only 24.5x12.5mm, and weights only 4g, enabling your builds to be even smaller and lighter!
Oneshot125
Oneshot125 is a different and faster communication protocol between the flight controller and the ESC on your quadcopter. It allows the FC to send control commands to the motor quicker, therefore in theory your multirotor should perform better.
Damped Light mode
This feature allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.
20A 3-4s
Capable of running 3s and 4s setups, LittleBee can work with up to 20A continuous load, and 30A peak (10s).
Easy upgrades
With the BLHELI software rapidly evolving, you can flash the lastest firmware using the 3pin connector and suitable USB adapter*
Specifications
Size: 24.5*12.5*3mm
Weight: 4g with wires
Signal Wire: 100mm
Motor wire connector: Soldered Wire
Signal Wire Color : White / Black
Battery wire connector : Soldered Wire
Motor Cable Length : 50mm
Continuous Current: 20A
Motor Cable Gauge : 20#
Burst Current (10s) : 30A
Motor Wire Color : Black
No. of Cells (NiMh) @ 5-12NC
Battery Wire Length : 100mm
No. of Lipo Battery Cells : 2-4Lipo
Battery Wire Gauge : 20#
BEC output : None
Battery Wire Color : Black/Red
Programmble : Yes
Outer Case : Clear Heat shrink
USB link programmble : Yes
Mosfet : All N channel
PCB board : 4 layer blind pole board, 3 oz copper