Nissan car audio interface cable with power and speaker ISO connections allowing use of original steering wheel buttons with a new aftermaket head-unit. Use with Nissan 350Z, Murano, Navara, and X-Trail models.

This interface connects a KENWOOD stereo with a jack plug input (on the back of the stereo) to the existing dynamicsounds00 Stalk/steering wheel controls of the vehicle.

Steering Wheel Adaptor suitable for following Vehicles:

• Nissan 350Z Coupe, Roadster : 2003 - 2010 (NON-BOSE)
• Nissan Murano I : 2005 - 2008
• Nissan Navara D40 : 2005 Onwards
• Nissan X-Trail : 2001 - 2007

Original Stereo must have either one of the following model numbers:

• CH340
• CNA48
• CY06A
• CY25A
• CK106
• CY03A
• CY12B

Installation Tip: Purple wire on patch lead is connected to blue/yellow wire on stereo.
A stalk/steering wheel control adaptor enables you to utilise the original factory remote audio (whether built onto steering wheel or fitted on a stalk next to the steering wheel) with an aftermarket unit.

PLEASE NOTE : If you have a dashboard mounted audio display then this will not work once the new stereo is fitted but your clock and temperature will remain.

IMPORTANT NOTE: Please make sure that is the correct Stalk Adaptor for your car by firstly checking to see if your make, model and year of car is listed in the advert. Secondly by checking to see if the connection in the picture listed is the same as you have in your vehicle.

If the connection in the car is different from what you see in the picture then this adaptor is NOT suitable.