Your decal comes in 3 layers. the top outer layer (application tape), the middle layer (the vinyl itself)
and the bottom layer (carrier paper).
Clean surface with a damp cloth or sponge to remove dust and dirt. Soap may be used to help remove
any oil that may be present. Make sure the wall is completely dry before placing the decal.
Lay the decal on a flat surface, face up, and run your squeegee or similiar (credit card or bank card can
be used) over the decal. This is to ensure that the vinyl transfers on to the application tape.
Once you have decided where your decal is going to be positioned, you may place in postion on your
wall using masking tape.
Gently lift the decal away from the wall, using the masking tape as a hinge, and peel away the backing paper.
Make sure none of the vinyl pieces are left on the backing paper - if this does happen, just use the squegee
and run it over the front of the decal to ensure transfer of all vinyl to the application tape.
Run your squeegee over the decal to apply the vinyl to your wall. Apply in a smooth motion from the middle of
the decal outwards to avoid any air bubbles to be trapped between the vinyl and your wall.
Wait 10-15 minutes and carefully peel the application paper back slowly. If any vinyl pieces stay on the
application tape, re-squeegee with more pressure and try again.
|