***If you want to buy more than one items i sell on eBay, ask for combined postage*** WITH THIS ADAPTER CABLE YOU CAN USE A Gotek USB Floppy Drive Emulator AND A 3.5" PC Floppy Drive Connected SIMULTANEOUSLY to the external drive connector of ANY AMIGA 500/600/1200! (set Gotek's jumper to 'S1' for stand alone use, or to 'S0', for use along with a pc floppy) Gotek/Pc Drive can be also connected alone either directly to amiga, or chained connected to external drive(s)! (note: Gotek drive must have the appropriate firmware for amiga, you can find more info about how to do this here: http://cortexamigafloppydrive.wordpress.com/2014/02/03/transform-the-gotek-floppy-emulator-into-an-amiga-floppy-emulator/ ) If you have an amiga 500 with 1.3 kickstart, i can provide a real 3.5" boot disk with the needed selector.adf , in order to use the cortex amiga emulator utility for the external connected gotek drive (DF1, DF2 or DF3) and place adf images to positions . Fully tested using an Amiga 500 with 1.3 Kickstart and Amiga 600 with 2.04 Kickstart, where many games/programs are also bootable from external drives using boot menu (press both mouse buttons on power)! Notes: - The cable might work with other floppy emulators too (for example HxC floppy Emu) but i can't guarantee it will do so. - As the needed 23pin D connector is difficult to find and rather expensive,i use a cut 25pin D connector instead. No need to worry about that, as it will plug perfectly like a real 23pin D connector! - If you are using HD 3.5" disks along with a pc floppy drive connected to amiga, be sure to cover the HD hole of the disk with a little duct tape in order to enable pc drive's DD/720Kb operation mode. - Although the adapter is tested with many 3.5" pc floppy drives,i can't guarantee that it will work with any 3.5" floppy drive existed. |