Ferric Chloride + Copper PCB + PCB Driller + Drill Bits
Products :-
1) 250gm Ferric Chloride (PCB Etching powder)
2) 4 Pcs of 15 cm x 10 cm Copper PCBs
3) 1 PCB Driller
4) 2 Pcs of Drill Bits (1 Pc of 0.8mm size & 1 Pc of 1mm Size)Features:-- Ferric chloride (PCB etching powder) is used for etching the Copper Clad board.
- The circuit may be printed or made by permanent marker on PCB, this works well with both methods.
- Copper clad boards are of 15 cm x 10 cm size, which is perfect for all general projects.
- Copper boards may be easily cut into another size as required.
- Copper boards can be drilled easily with this driller using 1mm Drill Bit & also with 0.8mm Drill bit.
You
will get two Cylindrical stands (Collects) with PCB Driller in which
Drill Bit is adjusted, One stand is for upto 0.8mm Drill Bits &
Other is for Drill Bits with size 1mm or more.
Precaution:- While drilling Place the PCB on Thermocol Plate & keep the driller straight.
SOME
IMPORTANT POINTS THAT YOU MUST KNOW
Note (1) : - Dear buyers, You must
know that the Copper side of these all copper PCBs is very sensitive towards
Water, Moisture, & Our Hands. When we touch copper side with our hand in
presence of moisture or water etc then at the place of touch Our finger Prints
or some spots might be left.
Note (2) :- When these PCBs are
made then they are fresh & spotless but while there cutting in factories
the workers have to touch it & they also keep it open hence due to moisture
& touching with hands, many spots may appear on copper side. We have given
picture of fresh PCBs but it may contain spots or may be Spotless also ,
depends upon moisture, So please don’t be shocked to see spots.
Note (3) :- These Spots will not
at all affect your Circuit. Because when you design circuit on PCB using
Permanent Marker or Glossy Paper &
after designing circuit you will Fetch the PCB in Ferric Chloride Solution.
After PCB fetching process is done, you will surely clean the PCB with any
Scrub & Soap etc. While cleaning it with Soap & Scrub etc , all the
Spots will be permanently cleaned. So its very easy, only a little scrub &
Soap can remove these spots.
*** Please Visit Our
store to See more Kits for beginners with different combinations like PCB
Designing kit, Ferric Chloride, PCB Driller Kits & Soldering Kits etc &
all items at less prices than others on Ebay. ***
..............................................----------------------------------........................................................
Thank you for visiting our Store