CNC 4 Axis MACH3 USB Breakout Interface Board Motion Controller Card Engraving

The item is a CNC system based mach3.You don't need to add other Hardware, and you can complete the signal conversion from the G-code to the movement of the stepper motor drive control. This card is compatible with most stepper drives and servo drives, and it is perfect weapon to replace mach3 parallel interface board.

  

 

Feature：

 

  

A  USB Port, this interface is connected to the computer through a USB line.You can use the software mach3 to control this board, Note that you should use a USB2.0 cable with shielding and ferrite core,and cable length should be not more than 2 meters.

 

 B  5V General INPUT Port,IN1-12,see as Figure 2-2,it is defined as COM, IN1, IN2, IN3, COM, IN4, IN5, IN6, COM, IN7, IN8, IN9, COM, IN10, IN11, IN12 from left to right, The interface uses opto-isolated, using common positive input,COM is used as the common Port. 

 

C  High 8 General IO output interface, Have a current drive capability within 10MA,defined as GND O17, O16, O15, O14, O13, O12, O11, O10, O9, O8, 5V from left to right.

 

D  5V General Input Port  IN13-IN26,it's a 2.54mm double pin port.

 

 E  The Yellow input terminals is power input within 12~36VDC., the up terminal is Positive and the bottom terminal is Negative.

 

F  Two Relay Output  relay R1 and R2 are set as O18 and O19 in mach3, each relay's 3 Terminal are CLOSE\COM\OPEN from up to down,

 

G  Spindle PWM speed port, the interface requires a reference voltage,eg.10V, the port is set as 10VIN 0-10Vout,GND from up to bottom.

 

H  Low 8 General IO output interface, have a current drive capability within 10MA, defined as O1, O2, O3, O4, O5, O6, O7, GND from left to right. O1-O5 are Open drain port. The Maximum drive current up to 100MA, wiring methods

 

I  5-axis stepper motor control signal output, defined as CK+\CK-\DIR+\DIR-. There are positive pulse, negative pulse, positive direction, negative direction. These port are common positive connection.Therefore, on the board of CK + and DIR + are linked together to 5V. So this board does not support the common negative connection. Wiring method refer to Figure 2-7. This card doesn't have EN signal, most drives on sale should not connected to the EN signal. It is defined as X \ Y \ Z \ A \ B channel from left to right

 

Voltage specification:

A. System input voltage: 12~36V;

B. Operating voltage of input interface: 5V;

C. Operating voltage of output interface: 5V;

D. Stepper motor control signal output voltage: 5V; 

 

 

 

Package Content： 

• CNC 4 Axis USB control card * 1
• USB cable * 1

Shipping & Handling Policy