This is a newly redesigned brace kit to strengthen the weak Upper A Arm mounting
points on SKI-DOO's XP-XR-XS-XM chassis. As many of you know the A Arm mounting
points can bend from impact before the A Arms bend causing expensive
repair. The A Arm should bend before the chassis so you can change an A
Arm instead of having to do a complete rebuild of the front end because
of a bent mounting point.
A common problem is when you hit something with the ski turned it
pushes the bottom of the spindle back. The Lower A Arm is stronger than
the Upper A Arm and because of this it will force the upper A Arm
forward and bend it's rear mount. Some won't notice it right away but if
you look at your shock and if it's not in the center of the Upper A Arm
or rubbing on the A Arm you most likely have a bent Upper A Arm rear
mounting point. You can still ride like this if it's not too bad but it
will drastically change the caster angle of your spindle and won't
handle well.
This kit will greatly strengthen this weak area.
The complete kit weighs 12.7 ounces or .79 lbs.
ALSO FITS 2013-16 SKI-DOO REV-XS, REV-XM AND XRS CHASSIS
Fits 2008-2016 Skidoo XP chassis except for models with the 550 fan Does Not fit the XR chassis with the 1200 4 stroke engine. Will fit the chassis with the 600/800etec engine.
Does Not fit 4-Stroke 1200 nor 600-900 ACE engines at this time
For more front suspension protection also use Grip-n-Rips Lower A-Arm /Suspension Module brace kit located in my ebay store under SKI-DOO BRACE/REINFORCEMENT
ALL KITS COME WITH MOUNTING HARDWARE AND STEP BY STEP DIRECTIONS FOR SIMPLIFIED INSTALLATION