|
Saves Money and Pays for Itself
Calculations based on: Water cost= $2.02/100ft3. Sewer surcharge = $ 1.35/100ft3. Notes: Use of insulated copper supply line on Autocirc system would result in additional savings. Actual savings may differ from household to household depending on a variety of factors incl. water use habits, length of hot water supply line, number of home occupants, etc. Above summary based study and analysis prepared by Edward Saltzberg and Associates, Consulting Mechanical Engineers. Copies of this detailed analysis are available on request from Laing Thermotech, Inc. |
Only 7 Basic Installation Steps:
- Select sink under which the should be located (Sink where hot water takes longest to arrive).
- Install a 115 volt outlet under sink or run cord to outlet near sink.
- Turn off angle stops valves and disconnect existing supply hoses from the hot and cold water supply inlets of the faucet.
- Attach 3/8" end of the new hoses to pump housing and attach other 1/2" end to the hot and cold water supply inlets of the faucet.
- Attach existing supply hoses from the angle stop valves to the 1/2" hot and cold water inlets of the pump.
- Set pump timer for desired operation period.
- Install the to the wall under the sink with the bracket provided. Turn on the water at the angle stop valves and plug in the 115 volt cord into the outlet. Turn on the desired run mode setting and the system is now operational
Tools Required:
- Adjustable Wrench
- Screwdriver
Parts Required:
- pump which includes pump with built-in timer, 6 ft. Line cord, and wall bracket.
- Two stainless steel wrapped flexible hoses (1/2" X 3/8" fittings) length as required to suit your installation.
Protected by one or more of the following patents: 5,941,275 / 5,944,221 / 5,983,922 / 6,026,844 6,059,965 / 6,149,407 / 5,072,717 / 6,227,235
|
|
|
| |
|