Lost the Touch pin FLUKE 80K-6 High Voltage HV Probe

Note: USED item , We can't test,I feel 60%-70% new.

the item probe Lost the Touch pin  you can see in the photo , so sale for parts only.

Item we sale: 80K-6 HV Probe Compatible FLUKE DMM (Fit most  Digital Multimeters ), The item we sale is old first version or new version. we random to ship.

Item include  :80K-6  itself only, no other accessories.

without any warAll items are listed as is ranty.

Please be sure this item fit for you before you buy.

==============================

The 80K-6 is a high voltage probe designed to extend the voltage measuring capability of an AC/DC voltmeter to 6000 volts peak AC or DC Overvoltage Category I. This means the probe can only be used to make measurements on energy limited circuits within equipment. Examples include high voltage within televisions or photo copy machines. DO NOT use this probe to measure high voltages on power distribution systems. The probe provides high accuracy when used with a voltmeter having 10 Megohm input impedance.

A high voltage probe that allows a multimeter to measure up to 6,000V. Intended for low energy applications only

Need  manual or more info: http://www.fluke.com/Fluke/usen/Support/Manuals/default.htm?ProductId=55358

Operation
Use the following procedure to operate the 80K-6:
1. Inspect the probe. (Refer to the preceding Warning.)
2. Connect the probe cable to a compatible voltmeter. (Refer to
the preceding Warning.) Use a shunt resistor if required.
3. Select an appropriate voltage range (1 volt reading per 1000
volt probe input).
4. Connect the ground lead of the probe to earth ground. (Refer
to the preceding Warning.)
5. Hold the probe by the black handle and connect the probe tip
to the circuit being measured. Observe the voltmeter reading.
Maintenance
Performance Test
Verify the probe accuracy by measuring a 5 kV dc ±0.25% voltage
source. When used with a compatible dc voltmeter, the probe
should accurately measure the source voltage to within ±1%. No
calibration adjustments are provided on the probe.
Cleaning
Use a soft cloth dampened with distilled water to clean the 80K-6.
Never use solvents or abrasive cleaners.
Disassembly
Use the following procedure to disassemble the probe:
1. Unscrew the black handle from the probe, and slide the
handle onto the cable.
2. Unscrew the metal tip one turn, and push in on the tip until
the internal assembly snaps free of the housing. Remove the
tip.
3. Withdraw the internal assembly from the probe by pulling the
metal ring over the threads on the probe body.
4. Logically reverse this procedure to reassemble the probe.
Caution
To avoid probe damage after repair, measure and, if
necessary, adjust the outside distance between the
ring and the probe coupling on the internal assembly
before reassembling the probe. The distance must be
4.910±0.020 inches. Make the adjustment using the
solder connection at the rear of the metal probe
coupling.

==================