Click to Enlarge
|
Click to Enlarge
|
Click to Enlarge
|
1 TTL interface, can be connected directly with UART on MCU. default baudrate: 115200bps
2 JPEG output the compression ratio can be set: 640X480 or 320 x 240
3 support CVBS output can be connected with AV output on tv
4 working voltage: 4.2V---5V
5 size: 3.2cm X 3.2cm, screw: M2 X4
6 package: one pc
PIN
(UART JPEG for 1--4 pin
(CVBS for 5--7 pin
1:TX (3.3V)
2:RX (3.3V)
3:GND
4:VCC (4.2V---5.0V)
5:VCC(4.2V---5.0V)
6:GND
7:VTO ( CVBS??/???????AV????)
commend?
1 Reset command:56 00 26 00 return?76 00 26 00
2 Photographing comment:56 00 36 01 00 return?76 00 36 00 00
3 read the length of the photo:56 00 34 01 00 return?76 00 34 00 04 00 00 XX YY
XX YY -------data length?XX for higher byte?YY for low byte
4 read the data commend:56 00 32 0C 00 0A 00 00 XX XX 00 00 YY YY ZZ ZZ
return:76 00 32 00 00?Interval?FF D8.......FF D9?Interval?76 00 32 00 00
00 00 XX XX ------start address(default: 00 00?
00 00 YY YY ------data length?higher one fistly then lower byte?
ZZ ZZ --------Interval?= XX XX*0.01 ms ? recommend 00 0A?
5 stop photo:56 00 36 01 03 return?76 00 36 00 00
6 Compression ratio command set :56 00 31 05 01 01 12 04 XX return?76 00 31 00 00
XX recommend 36 ?range:00 ----FF?
7 Set the camera picture size:?defaul?640*480?
56 00 31 05 04 01 00 19 11 ?320*240?return?76 00 31 00 00
56 00 31 05 04 01 00 19 00 ?640*480?
8 Modify the serial rate:56 00 24 03 01 XX XX return?76 00 24 00 00
XX XX rate
AE C8 9600
56 E4 19200
2A F2 38400
1C 4C 57600
0D A6 115200
default baud rate?115200
9 Initialization
?1?connect the power
?2?prolong 2.5 seconds
?3?reset
?4?set the size of the picture
?5?set the compassion rate of the picture
i000000
inkfrog terapeak
i000000
inkFrog Analytics