This is an auction for my Micro Mill/Drill Sieg 1 it is an imperial machine and i have fitted it with a motorised bed, there are a lot of accessories with this machine which i will list here
A windscreen motor drives the bed X Y access (i believe it's called) i have adapted w/screen motor to fit on the end of the lengthend drive screw connected via a dog clutch, so I could use the machine by hand if needed, it is powered by a battery charger giving it 4 speeds i have bought an electronic controller which would give the user better control over the speed of the bed, i have not fitted this because i do not know enough about electrics to do so! maybe the buyer can fit this although i have found the 4 speeds quite adequate in use, the controller can be just seen on the manual picture. there is also Chidlywink (chinese) drill chuck and key, this came with machine i have never used this. 4" rotary table HBM A multi angled revolving mill vise hardly used complete with spanners A set of Threaded Mill chucks in box End Mills (some brand new all British Made) roughly 1/8"-1/2" these are threaded to suit Mill Chucks Some Disc Mill cutters and Holders Some large Slot cutters Draw Bar to Hold Mill Chucks etc. Table Clamps as shown Set of Starrett wiglers I have enclosed directions with the Mill manual 6 Countersink bits 3/16"-7/16" plus a few centre drills needed for accurate drilling T-Slot Clearer I have fitted various stops on mill body Stainless Steel Protractor Brass Mallet for removing draw bar All Spanners and keys needed for mill and oil can Also there is a vertex lamp if needed There is everything here needed to get you going on milling! This is quite a heavy machine so will need two men to pick I will help where i can, but have substained a back injury (fractured Vertebrae) so please come with two men This will have to be a pick up job, I will leave it in situ so buyer can see it running, then we can unbolt and take it from there Paypal payment only! any questions please ask |