| |||||||||||||||||||||||||||||||||
- static window film uses no glue..!
- simply peel and stick
- blocks harmful rays of the sun
- reduces heat loss in winters and over heating in summers
Can be used for privacy e.g. bathroom windows, bedroom windows, back doors or for decoration e.g. glass on internal doors or front doors/windows. it will reduce more than 90% of sun's harmful rays, it will prevent heat loss in winters and over heating in summers, and it will give you privacy in day and night.
This
is a high quality PVC film (rather than other cheaper polyester (PET)
films you will see for sale). This means it is easier to handle and
install, and will last much longer without peeling or discolouring. Last
but most important, it is non-adhesive on the backing side. It means there will be no glue residue after you peel of the films.
FITTING INSTRUCTIONS
You
will need: - Roll of window film - Scissors/cutting knife - Tape
measure - Spray bottle containing water with a few drops of washing up
liquid - Squeegee or old credit card wrapped in kitchen towel
Method:
1) Thoroughly clean the window the film will be applied to.
2) Cut your film to size of the window, adding an extra 2cm to the width and height.
3) Remove the clear lining film from back of the window film and spray the back of the film, with the soapy water solution. (Tip: If you cannot remove the clear lining film, attach a piece of sticky tape to either side of the film at one corner and peel away from each other).
4) Spray the glass with the soapy water
5) Apply the film onto the glass and slide into position
6) using a squeegee or credit card wrapped in paper towel, squeegee out all the soapy water from behind the film
7) Trim off any excess film using a sharp knife for a neat finish
Method:
1) Thoroughly clean the window the film will be applied to.
2) Cut your film to size of the window, adding an extra 2cm to the width and height.
3) Remove the clear lining film from back of the window film and spray the back of the film, with the soapy water solution. (Tip: If you cannot remove the clear lining film, attach a piece of sticky tape to either side of the film at one corner and peel away from each other).
4) Spray the glass with the soapy water
5) Apply the film onto the glass and slide into position
6) using a squeegee or credit card wrapped in paper towel, squeegee out all the soapy water from behind the film
7) Trim off any excess film using a sharp knife for a neat finish
if you require longer lengths, please purchase multiple items and you will be sent one long roll of film in continuous length.
FEEDBACK : Our business survives on customer feedback, therefore , it is very important for us. Please if you are not satisfied with anything , just email us and we would be more than happy to resolve any problems. Please do not leave any negative feedbacks or low ratings.
THANKS FOR LOOKING PLEASE DO CHECK OUT OUR OTHER ITEMS FOR MORE GREAT DESIGNS:)