YOU ARE INVITED TO BID FOR A HIGH QUALITY EUMIG MARK 501 SUPER, SINGLE & STANDARD 8mm AUTOMATIC SILENT CINE PROJECTOR, FULLY TESTED** WITH FILM AND HAS PROVEN TO BE IN GOOD WORKING ORDER WHEN FILM TESTED, COSMETICALLY IT IS IN A TIDY USED CONDITION, WITH A FEW PAINT CHIPS, CONSISTANT WITH AGE AND USE. SUPPLIED WITH THE ORIGINAL "INSTRUCTIONS FOR USE" LEAFLET, MAINS LEAD AND A NEW 200' TAKE-UP REEL, ALL SUPPLIED IN ITS ORIGINAL EUMIG BOX & ORIGINAL POLYSTYRENE PACKING MATERIAL......I've just fitted a new rubber drive belt, plus a new 12v 50w halogen lamp, also 3 replacement rubber feet, so it's all ready to show your precious old movies!

(The "Mark 500" series were amongst the very best of the famous Eumig products, being very sturdy & having a reliable belt drive system):...Please see all 12 photographs:

THIS PROJECTOR IS FULLY FILM TESTED** BY PLAYING BOTH SUPER 8mm & STANDARD 8mm FILMS THROUGH IT AND THE RESULTS WERE VERY GOOD, LOADING THROUGH THE GATE WITH THE AUTOFEED WAS ALSO VERY GOOD, GIVING A GOOD STEADY BRIGHT PICTURE:

**Fully checked and tested by the seller, a former "Rolls Royce" trained engineer and Cinematic Enthusiast for over 40 years:

SOME OF THE SPECIFICATIONS :-

FORMAT SIZES:- Super 8mm / Single 8mm & Standard 8mm: (easily switchable):

MAXIMUM REEL CAPACITY:- 120m - 400 ft: (supplied with a new 200' take-up reel):

FILM LOADING:- Autofeed of Film from Reel to Reel:

PROJECTION SPEEDS:- 18 fps and 9 fps (slow motion) in forward Projection:

PROJECTOR LAMP:- 8 Volt 50 Watt type A1/185....switchable to half power; (new lamp fitted):

PROJECTION ZOOM LENS:- High Quality Eumig Eupronet f1:1.6 /18mm....(Made in Austria):

REWIND:- Rapid though the gate:

MAIN CONTROL WHEEL:- To control this projector is very simple....CLOCKWISE :- At rest is at the 9 o'clock position, film threading is at 10 o'clock, lamp on (half power)& slow motion (9fps) is at 12 o'clock, normal speed (18fps) & lamp on (half power) is at 2 o'clock, normal speed (18fps) & lamp on at full power is at 3 o'clock, Finally at 6 o'clock the lens assembly will swing open to allow a rapid rewind or to quickly review a previous portion of film (very useful):

ELEVATION:- By a screwed front foot:

NOTE: THE MAIN BODY OF THIS PROJECTOR IS CONSTRUCTED FROM A GOOD QUALITY DIE - CAST METAL ALLOY, MAKING IT MUCH STRONGER THAN OTHERS OF PLASTIC CONSTRUCTION. EUMIG WERE WELL KNOWN FOR THEIR QUALITY PRODUCTS, BUILT TO LAST FOR MANY YEARS: (PLEASE SEE ALL 12 PHOTOGRAPHS)

POSTAGE COST: PLEASE NOTE THAT THE COURIER SERVICE COST SHOWN BELOW IS FOR THE "UK MAINLAND" ONLY & DOES NOT INCLUDE CHANNEL ISLANDS, ISLE 0F MAN, ISLE OF WIGHT, NORTHERN or SOUTHERN IRELAND & THE SCOTTISH HIGHLANDS..for any of these areas or foreign country, please email me for a quotation before bidding!

NOTE: This projector produces a very steady picture and is a typical high quality product from Eumig and as such with it's dual format & slow motion capability it could be used to produce the images for your **cine / video / DVD transfers: ** Please note that further equipment is required to enable transfer!

THIS QUALITY PROJECTOR WILL BE PACKAGED AS FOLLOWS :-

IT WILL BE SUPPLIED LOCATED IN ITS ORIGINAL EUMIG BOX (box is tatty so it will all be placed inside a further box for safer travel), WITH POLYSTYRENE PACKING MATERIAL, PLUS ITS MAINS LEAD WHICH IS FITTED WITH A NEW MODERN DAY SLEEVED SAFETY PLUG (protected by a 5amp fuse), A SUPER 8mm REEL ADAPTOR, THE ORIGINAL "INSTRUCTIONS FOR USE" LEAFLET,...PLUS A NEW 200' MANUAL TAKE-UP REEL: (PLEASE SEE ALL 12 PHOTOGRAPHS)

PLEASE NOTE: The projector stand and front reel with film shown in some of the photographs are not included in the auction:

MADE IN AUSTRIA (This is a genuine Eumig manufactured cine projector serial # 2919218)

THANKS FOR YOUR INTEREST!