Lathe bed wipers made to fit Colchester Chipmaster and Bantam , Made as close as possible to the original ones in ABS plastic

Very important to have them as they keep the swarf from getting under the carriage slides

The original ones are now impossible to obtain and would be fragile as they were made in a Bakelite material

Do not be confused with felt ones as these soak up the coolant, turn into a soggy mess and promote rust where they stop and rubber ones quickly wear on their working edges

Their purpose is just to clean the slides, not  to lubricate them, This is done with an oil can through the many oilers on the top of the carriage 

A set consists of two Vee and two Straight wipers and will replace the original ones on the Colchester Chipmaster Lathe and Bantam Mk1 & Mk2

Very easy to fit, remove the Allen key screws, scrape away the old wipers and fit these new ones

Shields shown in picture 2 are available see my other listings

Many thanks to John Crisp for his help in supplying the information to make these and for testing them on his own Chipmaster  

Also thanks to Hugo Kennedy for testing them on his Bantam

Since I started making Bed wipers I have had positive feedback from my customers many of them pleased that they are available again

If you are having trouble identifying your lathe go to www.lathes.co.uk lots of useful information there

These will not fit on a Bantam Mk3 or Harrision M250 M300 see my other listings 

If you have any questions then please drop me a line and I will try and help

I have the wipers for the Student and Master Mk1 & 2, Student 1800 and Triumph 2000 Triumph Mk1 so if you require these  ones then please see my other listings