This fan coil may be installed free--standing, wall hung or flush

mounted in the wall. The 22” (559 mm) wide cabinet size in all

models allows units to fit between standard stud spacings. No

return--air ductwork is required if the application provides for

return air in the front of the cabinet through either a louvered closet

door or an optional accessory decorative grille panel.

The cabinet exterior is made of pre--painted, galvanized sheet

metal. The cabinet is fully insulated to meet applications in

conditioned space. Additional insulation is required if the unit is

installed in an unconditioned space. The unit is supplied with a

replaceable filter.

Multi--speed, direct--drive, PSC blower motors have been selected

to provide the proper air handling for both heating and cooling.

Electronic commutating motors (ECM) use X13 high--efficiency

motors to increase system performance. Motors are suspended at

three points on rubber grommets for quieter operation.

All refrigerant lines, electrical power, and thermostat wiring enter

from the top of the cabinet. Sweat--type refrigerant connections on

both liquid and suction lines make for swift, low--cost installation.

All service access to the unit is conveniently located in the front.

All units come with a factory--supplied, hard--shutoff thermostatic

expansion valve (TXV) metering device for performance

improvement.

The drain pan is constructed of high--impact, sound--deadening,

corrosion--proof polyester resin. Primary and secondary drain

connections exit from the bottom or either side of the cabinet.