|
FOR AUCTION A VERY RARE OPPORTUNITY TO BUY THE ULIMATE PIECE OF TUNING KIT FOR THE FORD V6 ESSEX ENGINE
I'M SELLING A TRIPLE WEBER KIT COMPRISING OF THE FOLLOWING PARTS TO FIT ALL CARS FITTED WITH THE FORD V6 ESSEX ENGINE CAPRI - GRANADA - TRANSIT - MARCOS - TVR - SCIMITAR TO NAME A BUT A FEW
THE SALE IS FOR THE FOLLOWING ITEMS 1 TRIPLE WEBER INLET MANIFOLD - USED AND UNPORTED AND VERY CLEAN 3 - 40DCNF WEBER CARBS OF THE LATER TYPE - NEW OLD STOCK - NEVER FITTED 3 AIR INTAKE TRUMPETS - NEW FROM JENVEY - MAY NEED TRIMMING DOWN TO SUIT YOUR INDUCTION AND FILER SYSTEM 1 FUEL RAIL - USED 3 FUEL RAIL BANJO BOLTS - NEW 6 FIBRE WASHERS FOR THE BANJO BOLTS - NEW 1 THROTTLE LINKAGE - USED AND HOME MADE AS NOT AVAILABLE 3 CARB REBUILD/GASKET KITS FOR PEICE OF MIND - NEW 3 HEAT INSULATION BLOCKS - USED 12 MANIFOLD TO CARB STUDS - NEW AND NOT FITTED 12 MANIFOLD TO CARB NYLOCK NUTS - NEW AND NOT FITTED 12 NUTS TO SECURE THE RAM PIPES - NEW 8 CAP HEAD BOLTS TO SECURE THE MANIFOLD TO THE ENGINE - USED NOTE - THE THROTTLE ARMS ON THE CARBS ARE FROM A FERRARI , AND ARE USED IN FACT JUST ABOUT EVERYTHING YOU WILL NEED TO FIT THIS TO YOUR ENGINE APART FROM THE INLET MANIFOLD GASKET , ROCKER COVER GASKETS AND A MEANS OF CONNECTING YOUR THROTTLE CABLE.
THE PICTURE YOU SEE IS A LOOSE FIT MOCK UP AS THERE ARE NO STUDS FITTED TO THE MANIFOLD , AND IN ORDER TO FIT THE CARBS - YOU MAY NEED TO EITHER BEND THE MANUAL CHOKE ARMS OR REMOVE THEM AS THE CARBS DO NEED TO BE VERY CLOSE TO EACH OTHER WHEN INSTALLED ON THE MANIFOLD .I HAVE NOT DONE THIS AS THE CARBS ARE NEW OLD STOCK. PLEASE SEE THE CLOSE UP PICTURE OF THE CARB BASE TO VARIFY THAT A NUT HAS NEVER BEEN TIGHTENED DOWN ON THESE CARBS.
PLEASE NOTE THAT THE MANIFOLD HAS BEEN USED FOR A VERY SHORT PERIOD OF TIME - AND IS UNPORTED - HOWEVER THERE IS A LITTLE GASKET STAINING TO THE ALLOY FACES - BUT ALL FACES ARE FLAT AND CLEAN AND STRAIGHT. THERE IS NO CORROSION TO THE WATERWAYS AND THE THERMOSTAT HOUSING IS NOT CORRODED. THERE IS A WATER OUTLET AT THE REAR THAT WILL NEED A BSP PIPE FITTING THERE IS A VACUUM TAKE OFF INSTALLED THERE IS A BLANK AT THE BASE OF THE THERMOSTAT TO FIT A FEED TO THE WATER PUMP IF REQUIRED. PLEASE BE AWARE THAT ONCE ASSEMBLED AND INSTALLED - YOU WILL NEED TO BOOK A ROLLING ROAD TO GAIN THE MAXIMUM POWER FROM THIS SET UP. THIS WILL INVOLVE POSSIBLY CHANGING JETS ETC ETC HAVING SAID THAT - I HAVE LIFTED THE TOPS OF EACH CARB , AND CAN CONFIRM THAT FUEL HAS NEVER PASSED THROUGH THESE CARBS - HOWEVER THERE IS SOME TARNISHING TO THE CHOKES - HENCE MY INCLUSION OF THE GASKET KITS FOR PEACE OF MIND. MORE PICTURES AVAILABLE UPON REQUEST. I HAVE A SIMILAR SET UP ON MY CAR NOW - SO IF YOU NEED A PICTURE OF HOW THIS CAN LOOK - JUST ASK
ANY QUESTIONS PLEASE ASK. |