RTL.SDR+UpConverter Very wide SDR receiver 100KHz to 1766MHz, operating frequency Covers all HF amateur bands
RTL-SDR TECHNICAL SPECIFICATIONS
· Fully assembled and ready to use
· Uses RTL2832U+R820T chip set
· 100KHz to 1766MHz, operating frequency
· Covers all HF amateur bands
· Covers VHF & UHF bands from 24-1766MHz
· Up to 3.2 M Sample rate. (~2.8 MHz stable)
· Receiver modes AM, NFM, FM, DSB, USB, LSB and CW
· Note: depends upon the SDR software used with the receiver
· 8-bit ADC giving ~50 dB dynamic range
· 50 Ohm input impedance
· Double SMA golden antenna connectors
· Diode protection on RF input
· Aluminum panels
· LED power and band indication
· 40MHz local oscillator for HF conversion
· DBM balance ring mixer
· Small size board
· Free software
· Independent antenna inputs for Shortwave and VHF
· USB computer connection ( mini usb) Powered by common USB
· Very High dynamic range receiver
· SPDT High Power UltraCMOS™ RF Switch
· Accurate and efficient band filters
· Very clean audio reception
· All specifications subject to change without notice
Operation on HF.
• Click in “ON” Shift box
• make sure you enter the correct SHIFT frequency (minus) -40 000 000
• Switch on SDR toggle switch, red LED will light
• Tune your SDR Sharp on the bands.
• Reception on this mode from 100KHz to 30MHz
• Input antenna is HF
Operation on VHF and UP:
• Click “OFF” the Shift box
• Switch off the SDR toggle switch. Green LED off
• Tune SDR on the band you wish to receive
• Reception from 25MHz to 1.766GHz
• Input antenna is UV
Frequency offset settings for HDSDRclick Options or press F7, select RF Front-End+CalibrationIn the select the options within the red line, make sure that the input offset frequency 40 000 000 correct. The first to cancel the selection back to the default.