Wireless receiver controller:
●Frequency:
A649:
315MHZ
A650: 433MHZ
●Frequency deviation:
+0.2mhz/-0.2mhz
●Operating
voltage:DC12V
●Operating
Current:≤7mA
●Operating
temperature: -40℃~+80(℃)
●Receiving sensitivity: ≥-105dBm
●receiving
distance: 200m (100-200m to the max for open spaces)
●46x30x15mm (about)
●Modulation: AM
●Encoding
Type: learning code or fixed code
●Signal output method to adjust:
Latch-signal/interlocking: Press one button
is working ,press another button is stop ( one channel switch(
receiver )need 2 buttons remote control (transmitter)
Momentary-signal momentary/Jog/Non-Latched:
Press and hold button->ON, Release->OFF (one channel switch (receiver) need
one buttons remote control (transmitter ))
Toggle-signal/self-locking/Self-Latched:
press one button for one time is working .press the same button again is
stop ((one channel switch(receiver) need one buttons remote control
(transmitter))
●Learning and remove method:
It can work with fixed code
remote control directly once installed
(make sure your remote control
is in well condition. You can check the remote control in our shop if
needed).
If you use it for remote control
with learning code:
1.Press the learning button
(on the receiver), it means it has been putting in the study when
the indicator light are flashing. ---then you press any buttons of the remote
control to transmit signal. it means studying successfully when the
indicator flash 2 times until the light goes out .
2. it can learn more than 12 PCS 2262/2260(fixed code) or 1527(learning
code) chip with the different code
wireless remote control
3. remove/clean :press the learning button about 8 seconds , the indicator
turn on to off , it means the information that you keep have been removed
successfully