More Surprise are waiting for you here !
Features:
100% quality and Brand new.
Appearance, novel structure, easy to use and clean Desoldering
It can easily change components from the circuit board taken down without damage to the components and circuit boards
Electric suction tin can draw the melted solder extremely accurate, smooth disconnect parts
Description:
Voltage:AC 220V-50Hz
power:30W
Preheat:3-5 minutes
Notice:
Check voltage match, too high or too low voltage is not conducive to use
Tighten of Tsui and pump part, want to suck before use to prevent leakage, and otherwise affect Desoldering effect
Often cleared to enter the solder impurities within the suction nozzle and the pump, and a little oil to the piston and
After each use, to push the piston 3-4 times to remove residual solder within the straw to make the nozzle and straw smooth, so that the next time you use
The Desoldering energized, non-installation and removal of the electric part of the Parts
Usage:
Stuck the piston handle is pushed down, Desoldering iron absorption Tsui front end alignment intention of seizing the next element of the solder joints, pressing the control button until the solder melts, the solder shall be sucked into the pump within
Removing the pump when the the pump upper end of the direction of the arrow forced under pressure and poor at the same time the pump handle is pulled, the pump can be separated out, remove the suction nozzle, suction nozzle counterclockwise spin move, the suction nozzle to remove
Package Included:
1 x SOLDER SUCKER DESOLDERING PUMP
1 x PCB board through the needle
1 x 1.4mm nozzle
1 x 2.0mm nozzle
More surprise are waiting for you here !