Walnut wood veneer sheet 24"x 48" with peel and stick PSA peel and stick pressure sensitive self adhesive 2' x 4' x 1/40" thickness. A grade quality. Grain runs longer direction. Adhesive is already on the product which has a paper backer as well. Simply peel off the protective liner and the adhesive is ready to be laminated to most smooth clean surfaces. Most any finish can be used. Ships rolled in long narrow b ox with application instructions. This adhesive is very high quality and made by 3M as shown in one photo. Other sizes, backers, raw veneer ans edgebanding are available. Faster shipping is available.
Photos are representative of actual stock which will vary in color and grain appearance from photos since this is a natural product. Some photos may show other sizes, customer projects and wet or finished veneer. This product is unfinished. Each sheet carefully inspected and packaged by our company, not a third party "drop shipper".
Trust the knowledge, experience, and reputation of our company, serving the wood industry since 1995.
About pictures: Most pictures have been temporarily wet on the lower portion of the veneer to show what the grain may look like when finish is added. Color adjustments have been made to show the color as best as is possible. It is impossible to get photos exactly correct in color, but we have made an effort to do so.
Backed products come with complete application instructions that are simple and clear. For raw veneer or un-backed products, we suggest using the Internet to see what advice is available as opinions vary on the best way to handle that product. Below is general information for most of our products. Make sure you check the listing to see which applies to the above product in particular.
Thickness: (will not always be exactly correct, but relatively close)
Paper-backed veneers = 1/40”
Wood-backed veneers = 1/25”
Raw plain veneer with no backing = 1/32”-1/42”
How to cut: generally cut with a razor/box knife or similar tools and some type of straight edge.
How to apply: Paper-backed and wood-backed veneers are generally applied with contact cement (except when buying peel and stick). Raw plain veneer is applied with white or yellow wood glue and must have pressure applied while drying.
How to finish: most any conventional finishing products can be used with veneer that is applied correctly.
Disclaimer: Sometimes veneers have minor splits or tears in them. These are usually taped or repaired in some manner and shouldn’t impact overall quality or satisfaction. There may also be some minor wood filler used to fill cracks and other crevices that may exist. Wood products are rarely perfect and some consideration of that may be needed occasionally since this is a natural product and is rarely ever perfect.
Some sanding is usually required before finishing to prepare the surface for a finish and occasionally to remove veneer tape, splice glue, or some other imperfection.