Feature:

1) Wide range temp control
2) Cooling/heating control
3) Support Calibration
4) Support Delay Start
5) Support High Temp Alarm

Can select cooling or heating working mode.

Set highest/lowest upper limit temp to avoid accident.

Temp correction,you can calibrate temp according to requirement.Temp(after)=temp(before)+ correction value.

Delay start to protect your device.

High temp alarm,when measure temp reach to the setting temp,controller will alarm.

Restore factory settings,when the setting value is confusion, please restore factory settings.

Hysteresis setting,for example,environment temp is 30℃ and it is cooling mode, the setting temp is 25℃,the hysteresis setting temp is 2℃, cooling reach to
25℃ the relay off, and when temp is over 27℃ ,the relay on and cooler start, the 2℃ hysteresis keep is between 25℃ to 27℃.

Parameter:

Temperature control range: -50 ~ 110 ° C
Resolution: -9.9 to 99.9 is 0.1° C , 1 ° C temperature ranges other
Measurement Accuracy: 0.1 ° C
Control accuracy: 0.1 ° C
Hysteresis accuracy: 0.1 ° C
Refresh rate: 0.5 S
High temperature protection: 0 ~ 110 ° C
Input Power: DC12V
Measuring inputs: NTC (10K 0.5%) Waterproof sensor
Output:10 a relay all the way
Environmental requirements: -10 ~ 60 ℃ Humidity 20% -85%
Power consumption: Static current:<=35MA, Attract current:<=65MA
Easy and convenient to use
Size: Approx. 48 (L) x 40 (W) x 14 (D) mm
Total weight:20 g
Package weight:30 g

How to use:

Connect 12V power and the load.

Setting the desires temp:

1,press the SET button,the display flashs the temperature.

2,Press +- button to change the temperature number.

3,Press SET to save and exit after setting successfully.or no operation 10s,temp save and exit.

Select code(woring mode)

1,Select code PO:long press SET button 5s,the led display PO,then press SET button.set cooling or heating mode.

2,Select code PI ...P8:Iong press SET button 5s,the led display PO,then press +- button to change working mode

3,Press SET to save and exit after setting successfully.or no operation 10s the value will be saved and exit.

Code Code Description Setting range Factory setting
P0 Cooling /Heating C/H C
P1 Hysteresis setting 0.5-15 2
P2 Highest setting upper limit 110 110
P3 Lowest setting upper limit -50 -50
P4 Temperature correction -7-7℃ 0
P5 Delay start time 0-10 Minutes 0
P6 High temperature alarm 0-110℃ OFF

Long press + & - boot to restore to factory setting

Package Include:

Temp controller x 1 (DC 12v Blue version)