Jetted Whirlpool Bathtub Pump - 1HP (1.5 SPL), Single Speed, 1.5" Drain Down Suction x 1.5" Center Discharge:

Description:
1hp (1.5hp SPL),
115volt
3450rpm
13.6 amps
1 Speed
Thermally Protected
Industry Standard -1 1/2"  Drain Down Suction with Center Discharge.
3' Power Cord
Internal On/Off Air Switch (air switch connects to your existing tub side air button)
Note: This pump is equipped with an air switch. If the motor does not start upon plugging it in, the switch may be in the off position.
This pump has an Internal Air Switch (works with your existing tub side air button) or the air switch can be left in the on position for timer or wall switch on/off activation.

This pump also has built-in ports for adding a Thermal Wrap Heater Jacket.

Note: The Thermal Wrap Ports are not drilled through on this pump for use without Thermal Wrap.  If adding a Thermal Wrap the ports can be drilled through.

Optional- Thermal Wrap Description:


Tub water circulates through a serpentine path in the Thermal Wrap, collecting the heat generated by the pump/motor

and recycles that heat to the tub water - were it belongs!


Thermal Wrap - Heat Transfer System


This patented heating system for hot tubs/spas and Whirlpool Baths, captures and recycles the waste heat "energy" produced by the pump/motor and delivers that heat to the hot tub or bath water.  The Thermal Wrap system will heat and maintain water temperature.  The system allows the motor to run cooler; increasing the motors longevity and efficiency.  There are no moving parts and nothing to wear out.  Made in the USA!


Efficient:

- Patented design, over 1,000,000 in use

- Special thermal conductive inner heat transfer liner

- Models available for most 48 frame thru bolt spa/hot tub and jetted bathtub pump motors


Economical:

- Maintenance free - no moving parts to wear out

- Helps keep motor cooler - increases motor longevity and efficiency

- Cost less than electric heaters

- No additional electrical circuits required for installation


Safe:

- Manufactured of non-conductive materials

- Non electrical

- Self draining design (required for whirlpool bath application)

Thermal Wrap Heat Jacket "Retro-Fit" Kits are available for most spas and whirlpool jetted bath tubs.


Also available in 3/4 and 1hp versions

Replacement pump and motor for most all whirlpool Bathtubs.

If you have any questions, please do not hesitate to contact us.

Please contact us for international shipping costs.


Thank you