400:1 TFR (Non-Caustic)
2 x 5L (10L Total)
CSV Traffic
Film Remover is a rich, dense foam which was created to agitate, lift and
remove even the toughest dirt and traffic film. This specially designed formula
penetrates dirt and leaves behind a shiny finish, whilst leaving the paintwork
unharmed and looking like new. Our CSV TFR is completely non-caustic and will
not affect the finish of your paintwork. Please be aware this TFR is a high
foaming formula so take care with usage.
To use this
product, simply apply into a power sprayer or apply a spray head onto the
provided bottle. Completely cover the exterior of the car and allow working for
around ten minutes if any stains are particularly stubborn then feel free to
use a sponge, after this time has passed please rinse the entire car from top
to bottom. You can rinse twice if you wish to remove any remaining residue.
After this you should simply allow to dry naturally or use a shammy for a
flawless finish. With regards to dilution, fill the container with either hot
or cold water then add the solution and mix well.
Please Note:
The colour and accessories as seen on these images may look slightly different
due to lighting and other factors, if you should require a specific colour then
please get in touch with us.
Health
& Safety
Please do
not use this product neat as it is a concentrated formula, see dilution
rates which can be found on the bottle.
This is a
low hazard product so it is safe for normal use.
This formula
does have the ability to cause skin reactions and can cause serious eye
irritation.
We recommend
wearing protective clothing, gloves and eye wear to prevent hazard.
If on the
skin: Wash with plenty of water
If in the
eyes: Rinse continuously with water for several minutes (ensure contact
lenses are removed if this applies)
If eye
irritation continues, please seek medical attention.
FAQ’s for Non Caustic TFR
Is this product damaging to
paintwork in the long run?
ANSWER: No! This product is not at all
damaging to the paintwork. Other companies advertise TFR as “slightly alkaline”
which means it is caustic and over time will ruin paintwork by dulling the
colour and could ruin the finish of any aluminium you have on the vehicle.
What is the dilution rate
for this product?
ANSWER: You should dilute this
product at a rate of 100:1 and it is ready to use.