Se acquisti più pezzi di questo articolo, potresti risparmiare sulla spedizione!

Riempi il carrello e clicca sul pulsante 'RICHIEDI IL TOTALE AL VENDITORE' o contattaci per offerta personalizzata!


MODULO TINY85 compatibile con DIGISPARK KICKSTARTER ARDUINO


USB DEVELOPMENT BOARD con Atmel ATtiny85


Prodotti simili in negozio:

Micro scheda ATmega32U4 USB : >> https://www.ebay.it/itm/113153923193




MODULO ATtiny85

Micro scheda di sviluppo indicata per applicazioni in progetti che richiedono un numero ridotto di INPUT ed OUTPUT e spazi ridotti.

La scheda è gestita da un microcontrollore ATtiny85 e mette a disposizione 6 pin di input/output.

Presa microUSB per alimentarlo e programmarlo.

Alimentazione via microUSB o 5V esterni o 7- 35 V sul pin 'Vin'.

Strip di pin da saldare inclusi.

Le dimensioni della scheda sono 21 x 18 mm.



Esempi / tutorial :

HTTP://digistump.com/wiki/digispark/tutorials/connecting

HTTP://www.instructables.com/id/Digispark-DIY-The-smallest-USB-Arduino/?ALLSTEPS


English:

Digispark USB Development Board
The Digispark is an Attiny85 based microcontroller development board similar to the line, only cheaper, smaller, and a bit less powerful.

With a whole host of shields to extend its functionality and the ability to use the familiar IDE the Digispark is a great way to jump into electronics, or perfect for when an is too

big or too much.
The Digispark is shipped fully assembled except for the two included and easy to solder headers.

Here are the specs:
Support for the IDE 1.0+ (OSX/Win/Linux)

Power via USB or External Source - 5v or 7-35v (12v or less recommended, automatic selection)

On-board 500ma 5V Regulator

Built-in USB

6 I/O Pins (2 are used for USB only if your program actively communicates over USB, otherwise you can use all 6 even if you are programming via USB)

8k Flash Memory (about 6k after bootloader)

I2C and SPI (vis USI)

PWM on 3 pins (more possible with Software PWM)

ADC on 4 pins

Power LED and Test/Status LED


Peso conf.: 3,1 gr