STEP 1 Make sure that you clean the area thoroughly with soap and water then dry. STEP 2 Prepare the sticker for application by firmly rubbing a bank card or similar across the length of the sticker. This makes the sticker cling to the application tape. STEP 3 Slowly peel the paper backing off of the sticker. All parts of the sticker should now be on the application tape. If any parts of the sticker cling to the backing, slowly replace the paper and repeat step 2 STEP 4 Place the sticker onto the desired surface and rub it in place firmly with a bank card or similar. For best results wait a few minutes before moving on to the next step STEP 5 Slowly peel the backing paper off at an angle. Be careful not to pull the sticker off the surface. If the sticker pulls away from the surface please repeat the previous step.
Stickers can be reversed (for fitting on the inside of glass) on request