Will need to know the crystal frequency and chip type of the remote control before purchasing the remote control.

There are two conditions to be met when purchasing a copy remote control:

①The remote control you want to copy is usable.

②You need to know the crystal frequency and chip signal of the original remote control

Disassemble the remote control shell and check the circuit plate, there’s one frequency sound table and chip.

Copyable chip

Fixed code and learning code remote control, such as PT2240, PT2260, PT2262, EV1527, FP527, AX5326, PT2242, HT600, HT680, HT6207, HT6010, HT6012, HT6014, AX5326-4, SMC5026, SMC5326-3, SMC5326-4, SMC918, SMC918-3, SMC918-4, etc..

Copyable frequency:

303.5M, 310M, 315M, 330M, 350M, 370M, 390M, 418M, 430.5M, 433.42M, 433.92M, 868.35M, etc.

Product advantages

1. No need to consider the oscillating resistor, this product will automatically be compatible with the oscillating resistor.

2. The copy frequency range is wide, and the product frequency is 286-868MHz (the most common frequency in the market).

3. Can copy most fixed code and learning code wireless remote control, copy speed is fast, easy to operate.

4. Can copy remote control buttons of different frequencies at the same time, all in one.

Enhanced Type Copy Remote Control Operation Instructions

Ⅰ. Clearing method: Press and hold the front (upper) buttons at the same time, the LED indicator flashes three times, release any one of the buttons (the other one keeps pressing and holding), press the released button three times, and the LED indicator enters Fast flashing status, indicating that the clearing code is completed (the remote controller has been cleared, short press, the LED indicator does not light).

Note: Press the two buttons as much as possible at the same time, otherwise it will not enter the clear code state.

Ⅱ. Copy: One hand holding the original remote control, the other hand-held copying remote control, the two remote controls are close to each other, respectively press the button to be copied, the LED indicator flashes three times and then lights up continuously, indicating that the copy is successful, other buttons the operation method is the same.

Note: If the post-copy function is not normal, please clear the code and copy it again. (Recommended: replace the original remote control battery before copying)

Recovery instructions:

If the useful code is cleared by mistake, you can press the two buttons on the back (below) of the remote control at the same time without recopying the other remote controllers. After the indicator flashes rapidly for 3 times, the recovery is successful.