Full Glue UV Liquid Tempered Glass Screen Protector Samsung S9 S9+ S8 S8+ S10 S10+ Note10 NOTE 10+ NOTE 8 NOTE 9 S10 5G. This screen protector is one of a kind, it is made from a high tension tempered 9H glass for enhanced protection of your Phone screen which is then protected by a special film so even if you did ever manage to break the screen protector, it will not shatter into pieces, keeping you safe. Not only does the glass screen protector keep your phone free from scratches it helps strengthens the Phone screen which can help aid your screen from cracking or breaking when accidentally dropped, 3D Arc angle explosion proof, shatter resistant, more secure than other glass products. Surface is anti-oil processing (Oleophobic coating), so fingerprints and oil is not easy to stay surface, easy to clean some phones with curved edges the protector cannot fit right to the edge as this would leave an overhang of glass. This means that on selected screens the glass will be 1-2 mm smaller than the original screen. On this glass the small gap is intentional to allow for cases to be fitted as this avoids the glass being disturbed with most cases. Installation Notes: Please clean the phone screen before dispensing glue. Evenly drop the glue in the middle of the phone, then put down the tempered film of the mobile phone. The most important is that you must wait until the glue completely cover the screen of mobile phone, it might take 2-4 minutes, and then there is no air bubble on the screen. After adjusted the position of the Screen protector, then you can fix the film via the Uv lamp. (Screen protector can be adjusted before being fixed.) After fixing, if there is no glue on the edge of the phone, you can drop a little glue on the side and then fix it with the Uv lamp. If the screen is not completely covered, or there are bubbles in the middle,when you use the Uv lamp to fix it, bubbles will be generated, and the bubbles cannot be eliminated. How to install Before installation Please wear gloves and don't let Nano Water Liquid to Contact with your skin 1. Use Alcohol pad ( WET) to clean the screen thoroughly 2. Wipe dry with microfiber cleaning cloth (Dry) 3. Open Up the UV Glue Nano Water Bottle Cap 4. Cut the tip off the UV Glue Tube 5. Face Down the tip, this enables UV Glue to flow out 6. Drip the UV Glue Gently centre of the mobile phone 7. Peel of Plastic sheet from tempered glass 8. Match the position. Place tempered glass on UV Glue gently & Slowly, Let the UV Glue flow evenly, make sure no bubbles appear. 9. Wipe Off Excessive UV Glue on the edges with tissue. Before you use UV light 10. Plug UV Light, once's its on. Move the UV light gently on the full surface of the mobile phone OR YOU CAN WATCH VIDEO ON YOU TUBE HOW TO APPLY UV GLASS Terms & Conditions We are not responsible for any damage cause during the installation. Please don't try to use UV Glue screen protector on broken screen. Package includes
|