Have you been looking for iron-on wood veneer.
Found it either expensive, not in the widths or length required, or not in the species you want.
Look no further HOT/MLT/730 is here.
HOT/MLT/730 Is an iron on glue film, hot melt adhesive sheet. 730mm wide x 1mt long = 0.73 sq mt (28¾˝ wide x 39¼˝ long = 7.86 sq ft). For use with your own surfacing material. Suitable for wood veneering, marquetry and a wide variety of other crafts.
HOT/MLT/730 adhesive film comes on a release paper backing making it easy to handle and apply. It is very economical because even small pieces can be patched together to cover large areas, also it is very  forgiving because even when set it can be reactivated with the application of heat.
WOOD VENEER APPLICATION:
HOT/MLT/730  is applied to the prepared article/substrate you wish to veneer (glue side down) using a household/domestic iron on a medium setting.
As with any adhesive the substrate must be, clean, dry, smooth and free of dust, grease, wax & any other contaminates before application.
When cold, remove the backing paper from the glue film, the surface is now ready to accept the material of choice, ie wood veneer, leather etc.
At this point your iron should be turned up to it's maximum setting, i.e. 200º c.
The setting time of the glue film is practically instant, depending on the temperature of the actual glue.
For instance if one follows the hot iron instantly with a cold heavy metal object (such as the face of a carpenter's jointing hammer or old fashioned smoothing iron) applying pressure as one goes, not only will the curing time be greatly reduced , but bubbles or wrinkling can be eliminated.
NB: When applying the material of choice, it is advisable to use a sheet of brown wrapping paper (avoid printed paper) between the material to be applied and the iron to avoid scorching.
Do not use the backing paper for this purpose as the wax release coating will either be forced into the finish or coat your iron with wax.
If applying wrinkly or burr veneer it is sometimes advisable to double up on the hot melt film.
Not suitable for applying solid materials more than 1mm thick.
DISPATCH:
Lengths of 2mts or over will be rolled & packed in 760mm long cardboard tubes to eliminate creasing and dispatched via 1st class parcel
NB: 1mt lengths will be folded to fit in an A4 envelope to enable dispatch via Royal Mail 1st class large letter.

OTHER USES:

Being an EVA based hot melt adhesive, it can be used with a wide variety of materials, usable in heated presses or with a domestic iron and  suitable for bonding wood veneers, plastic laminate, leather, plastics, foams and fabrics, card & more. Test samples can be provided for the cost of postage ie £1.15

We always have plentiful stocks of this product available.

If the quantities listed are insufficient for your needs please contact us.