Upper: Suede split leather (cowhide), S3 water resistant treatment with front rubber reinforcement.
Lining: Polyester non-woven and knitted mesh.
Insole: Removable preformed - Polyamide on EVA.
Outsole: Cemented - Phylon.
Outsole: Rubber.
Non metallic boot.
RUBBER NITRILE OUTSOLE
Good resistance to abrasion and contact heat (HRO = 300°C for 1 minute)
Optimum grip
WELDED SOLE WITH PHYLON MIDSOLE (EVA)
Highest wearer comfort level and extremely light
Padded collar and tongue leads to a reduction of pressure points at the lacing
Outsole with protection rubber toe bumper - reinforced protection of the top of the toe area extending the life of your boots - if the toe-cap shows through then they no longer meet the requirements of EN345 and need to be replaced immediately
Heel support gives optimal stability of the foot when walking
Increased visibility
Anti-slide grip inside the shoe improved heel hold
Reinforced rear section
Preformed and removable EVA insole improved ergonomics and all-day comfort
REGULATION (EU) 2016/425
EN ISO 20344:2011 Personal protective equipment - Test methods for footwear
EN ISO 20345:2011 Personal protective equipment - Safety footwear.
| S3 HRO | Additional special requirements | |
| SRC | Slip resistance |