SKU:131216-031

 

 

 

NOTICE:This product is suitable for 220V only,  if you need 110V, please contact us. 

Feature:

• Applicable to the medium (such as glass, acrylic, plastic, ceramic, etc.) of various types of lamps.

• In the case of isolation without touching the metal parts of the sensor,it can sense the touch switch，high safety performance.

•  In the front of  mirror,switch is invisible,just see the touch background light.

• Touch the touch point, and the lamp will be ON; it will be off when you touch again;

• Wiring method: Connect the blue and brown wires to the AC100-240V power supply. Blue and red wires are connected to the light, and the black touch head is installed on the back of the mirror.
•  Working voltage:  AC220V 60HZ
•  Load type: dedicated touch switch ON/OFF (for energy-saving lamps, light tubes, LED light strips)

•  Load power: ≤300W

• Host Size: 90*36*20mm;   Touch switch: 50*34*10mm (except bracket), bracket size:57*46*12mm

Installation steps:

• Prior to installation, cut off power switch .
• Connect the blue and brown wires on the host to AC: 220V input, and connect the other set of red and blue wires to the output lamp.

• Fix the host in the required position with glass adhesive;

• Design a touch point on the mirror surface, with a size of 15-20mm. Firstly, remove the mercury around the touch point of the lens. The width of the removed mercury should be preferably 1.5-2CM, and the area where the mercury is removed should have a clear backlight. The touch position can be seen at a glance, which is both beautiful and convenient to find the touch switch position..

• When installing the switch, make a central cross line on the touch point. There are three arrow lines on the switch box, and the three arrow lines should be aligned with any three lines of the cross line on the touch point. (Because the center diameter of 10mm on the touch switch board is the touch sensing area, it is necessary to align the touch sensing area on the touch switch board with the touch point on the mercury part that has been knocked off the mirror surface.) Only after aligning the three arrow lines with the position can the touch be obtained, The touch screen comes with adhesive, and there is a sticker on the surface of the adhesive. Remove the sticker and align it with the marking position on the lens. There are three points on the bracket that are aligned with the center point of the mark, just on the opposite side. After applying it, the test switch should be tested to ensure that it does not fall off permanently. Other methods can be used to fix it properly..

Package includes

• 1x TQ-301SW On/OFF Touch Switch