JJBP 15mm to 12mm Fork Thru Axle Conversion Kit for KTM 15x100 thru axle disc forks used on the Revelator and Canic. Kit includes the following:



• Thread adapter: M15x1.5mm pitch external thread, 13mm long, M12x1.5mm internal thread

• Thru Hole Insert: 15mm OD x 12mm ID, 7.5mm long

• Axle: 12mm x 121mm long, M12x1.5mm threads, 5mm hex recess


IMPORTANT:

1. The Thread Adapter in this kit has no flange and installs from the INSIDE of the dropout due to the convexity of the outer fork leg on the KTM fork. The Thread Adapter comes with low-strength non-hardening threadlocker pre-applied to the threads. The fork threads must be clean and dry before screwing in the adapter from the inside of the fork leg until it is flush with the inner dropout face. Use a small coin such a penny or nickel engaged in the two notches, adding an adjustable wrench if necessary for more torque. A hair dryer or heat gun can be used to heat and soften the threadlocker if necessary.

2. Use grease on o-ring of thru hole insert and install into fork from the OUTSIDE with a combined pushing and twisting motion. Do NOT use thru axle to drive thru hole insert into the fork.

3. Use grease threads of thru axle. Torque using 5mm hex: 9-13.5 N*m.

Please contact me with any questions about this process.

See other auctions for many more sizes! Kits are available for nearly every 15mm thru axle fork ever made.


A note on international shipping: where applicable, when USPS First Class International shipping is selected you will be automatically upgraded to FedEx International Connect Plus (4-8 day transit time typically). Some locations are prohibitively expensive for this service (4-5 times higher than average) and as such will still receive standard USPS or Ebay International delivery. Please contact me with me any questions about transit time.