The device can be used for examining welded seams of thin-walled vessels, castings from light alloys based on magnesium and aluminum, beryllium, non-metallic workpieces and products (rubber, fluoroplastic, carbon, wood, plastic), electronic components with emitter fastening by ring handles.

Can heat so much so better to do oil warm-out:) - Seller notice

High-voltage power pulses with a duration of 100-400 μs are fed to the electrodes of the RAP 100-10 tube from the main transformer. The shape of the pulses is close to rectangular with a rise time of 20-25% of the pulse duration. The duty cycle is about 6-8. Between the power pulses, a reverse voltage of about 25% of the operating amplitude is applied to the tube, so the tube “rests” for a long time - secondary electrons and gas ions escaping from the anode dissolve, which can be released from the tube's structural elements.

Features:
original high-voltage power supply circuit of the monoblock increases the service life of the X-ray tube;
resistance to mechanical stress due to the use of oil as an insulating medium;
the built-in thermal relay stops the monoblock operation when the oil temperature reaches +60 ° С;
re-inclusion is 50%;
it is necessary to cool the anode with running tap water with a flow rate of at least
4 l / min;
it is possible to use the device with a liquid cooling module in the absence of a water supply network;
direct exit of X-rays through the beryllium window of the tube;
it is recommended to use special tripods to mount the unit.

Specifications
Maximum anode voltage 100 kV
Heater voltage 3.5V, Heater amperage 4.5A
Anode voltage adjustment range 30 - 100 kV
Anode current adjustment range 0.5 - 10 mA
Focal spot size:
- for tube 1BPV23-100 1.4 × 1.4 mm
- for tube 1BPV17-100 trapezoid: height 1.26 mm (middle line 40 mm)
Working beam opening angle:
- directional exit 40 °
- panoramic exit 40 ° × 360 °
Nominal transillumination thickness (Al) 56 mm
under conditions: F = 700 mm, D = 2, D4 film without reinforcing screens, exposure time 300 s, auto. processing, G135, +26.5 ° С, cycle 6.5 min
Exposure dose rate: at anode voltage of 90 kV and anode current of 4.0 mA at a distance of 0.5 m from the exit window
- directional output not less than 0.4 Gy / min
- panoramic exit not less than 0.6 Gy / min
Power supply single-phase AC, 50/60 Hz, 220 V
Full power consumption no more than 1.5 kVA