These
resin 3d prints have crisp detail, and don't suffer from the same layer
lines that are the bane of regular PLA prints. If you do find any, they
will be much easier to correct, as the resin is so easy to sand or
scrape with a hobby knife blade. So if you're looking for a finer finish
for your vehicles, they are definately the way to go.
Most
of the vehicles are printed in one piece with tracks or wheels
attached, and the tanks will have separate turrets. There will be very
small pinhead sized lumps that may need slicing or sanding off, but
these will be mainly confined to the undersides, and are a result of the
supports needed during printing (they are printed hanging upside down
from the build plate) and are unavoidable. I do take off the majority,
but I don't want to take all the fun out of it for you! It's also worth
noting that most of them are hollow, and have a large hole in the bottom, which serves
two purposes. It saves resin, and more importantly reduces the cross
sectional footprint when the model is being printed, which puts less
strain on the supports, reducing the risk of failures.
I
have many more files available, so feel free to contact me if there is a
particular model you want. You'll see a few listed with just an image
of the rendered files. Those are just some of the models I haven't had
the chance to fit into the build queue, and print examples of yet, but
they can be ordered and supplied just the same as the rest.
I
can't help the cost of international postage, but I can fit a lot of
models into a single box, so the more you order, the cheaper it becomes!