Small 4-pin NVR switch for induction motors up to 1.5hp, or brush motors up to 2.5hp

Common replacement Switch for many Woodworking and Metalworking machines, Pillar Drills (Clarke) etc
Simple to connect with clearly marked spade terminals
Dust Cover and Rear Seal
Responsive Buttons
Frequently fitted to many workshop machines, The switch disconnects in the event of power failure

The KJD17FT 110V switch is frequently used on many workshop machines. 
Rated at 18amp, it will be suitable for induction motors up to 1.5hp or brush motors up to 2.5hp. 
Simply connect using insulated spade terminals, the connections being clearly marked for input and output. 
It is a no-volt-release type of switch, providing safety in the event of an interruption of power. 
Requires a rectangular hole approximately 22 x 46mm, spring clips holding the switch securely. 

! All items are shipped from Leeds, UK and include a VAT Invoice !