5.0 Liter Jaguar / Land Rover Supercharger

GENUINE EATON PARTS

Eaton is the manufacturer of the Supercharger

2010-2013 All with the vacuum actuator - 47mm 

2014-2015 Electronic actuator - verify its 47mm by taking supercharger apart

• EATON Supercharger Snout Bearings (qty 2)
• EATON Supercharger Drive Hub (steel 3 pin part) (qty 2)
• EATON Supercharger Inlet Needle Bearings (qty 2)
• Quality Superchargers Replacement Isolator

Does not fit 3.0 liter engines

Installation Notes:

The snout is sealed to the supercharger with RTV (silicone), scrap off the old and apply some new sparingly. There is one bolt in the snout inlet on some superchargers, see 2nd picture. The TB gasket is reusable but a new one is C2Z28265. I recommend a bolt torque of 19 ft-lb for the snout bolts.

Jaguar Eaton TVS Snout Tear-down and Rebuild

youtu.be/nKcDWs0moqg

Supercharger Tear Down

youtu.be/BF9o6L_qd9E

Needle Bearing Install

youtu.be/122i15j3OK8

Tools used to remove Drive Hub & Needle Bearings

www.ebay.com/itm/115383943287

Drive Hub Puller

www.ebay.com/itm/113825453061