Specification:
Module Properties:non-isolated constant current & voltage moduleRectification: Non-Synchronous RectificationInput voltage: DC 7V-35VOutput voltage: DC 1.25V-30VOutput current: Adjustable Maximum 3AConversion efficiency: 92% (MAX)Switching frequency: 150KHzOutput ripple: 50mV (maximum) 20M-bandwidthLoad regulation: ± 0.5%Voltage regulation: ± 2.5%Operating Temperature: -40° C to +85 ° CSize: 48*23*14mmInstructions:
1.This module is an adjustable buck module that can be used to change the output voltage by adjusting the blue adjustable resistor on the module. The input and output voltage difference is 2V, and the minimum output voltage is 1.23V.
2.The IN- (input negative), IN+ (input positive), OUT- (output negative), and OUT+ (output positive) indicated on the module must be connected correctly. Otherwise, the module may be damaged.
Battery charging How to use:
1. Determine the float voltage and charge current of the rechargeable battery you need, the input voltage of the module;
2. Adjust the constant voltage positioner and adjust the output voltage to about 5V.
3. Use the multimeter 10A current block to measure the output short-circuit current, and adjust the constant current potentiometer to make the output current reach the predetermined charging current value;
4. The charge-to-light current defaults to 0.1 times the charge current (constant current value). If you need to adjust, please adjust the turn-on current potentiometer; (normally no adjustment)
5. Adjust the constant voltage position device to make the output voltage reach the float voltage;
6. Connect the battery and try to charge.
(1, 2, 3, 4, 5 steps are the module input power supply, the output is not connected to the battery.)
LED constant current drive How to use:
1. Determine the operating current and maximum operating voltage at which you need to drive the LEDs;
2. Adjust the constant voltage positioner and adjust the output voltage to about 5V.
3. Use the multimeter 10A current block to measure the output short-circuit current, and adjust the constant current potentiometer to make the output current reach the predetermined LED operating current;
4. Adjust the constant voltage position device to make the output voltage reach the maximum working voltage of the LED;
5. Connect the LED and test the machine.
(1, 2, 3, 4 steps are connected to the power supply of the module, and the output is not connected to the LED light.)
Package include:
1 PCS * Module