Ezfeeda (Multi-cup) 18mm 28mm 38mm
Comes with a FREE Rest that clips onto bait tray or bank stick

(bait tray not included)

The EZ Feeda is a SINGLE HANDED, non-tangle feeder that can be used for most loose feed and groundbait. It accurately fires loose feed up to 16 metres & groundbait up to 35 metres. Ideal for use with pole fishing, stick float or waggler fishing. All EZ Feeda’s are supplied with a self-threading Rest, which screws onto a bank stick or clips onto a bait tray.

Instructions

1.Clip the Rest to the side of a bait tray or screw onto a bank stick (fig 1).

2.The EZ Feeda should be held and used with the cup positioned underneath, & the carriage(a) held between the finger and thumb (fig 2).

3.When changing cup’s on a Multi-cup EZ Feeda, support arm(b) (fig.3).

4.To ensure accurate firing distance, adjust the distance stop, (O ring)(c) by rolling it along the shaft of the EZ Feeda .
Note: When setting distance stop to a maximum setting, 6cm must be left clear from the end bung(d), to allow holding space when firing
Four Methods of Loading Bait

1.Dropping bait into cup whilst the EZ Feeda is positioned on rest (fig 4).

2.Hold EZ Feeda as shown in (fig 2), & scoop bait out of bait tray (fig 5).

3.Hold EZ Feeda with the index finger over the cup and push bait into cup with your index finger (fig.6), then slide hand back into holding position (fig 2) (ideal method when using a bait apron or waggler and stick float fishing, as it allows feed bait and hook bait to hit water simultaneously).

To load groundbait hold the EZ Feeda as shown in fig 2, point the cup towards the groundbait, then turn your wrist inwards and gently push the cup into the groundbait in one movement (fig 7).

Firing

After loading, place the EZ Feeda onto the thigh in an upright position(fig 8), and using one hand pull the carriage back to the distance stop then grip the shaft(e). Smoothly aim the EZ Feeda in the firing direction at approx 30° angle and release the carriage.

Note Further firing distance on maximum setting can be achieved by moving your arm forward whilst firing.

It is advisable to remove cups from Multi-cup EZ Feeda when in storage.

Elastic should be checked regularly for wear.